Walton Primo G2 firmware Upgrade Flash Tools,Firmware & Procedore

WALTON Primo G2 Software update (AP+BP) Guide


Driver installation

1) Install AP part driver
Power off handset, press “Power key + Voice Up key” until the screen shows green, plug in usb cable, PC will remind you of installing new hardware. Unzip “ Driver”, select adb driver file, install AP driver.

Path: Right click on My computer>Manage>Device manager>Android(Yellow notification)>Update driver software>browse path> select adb folder >Continue anyway>finish
When you install AP driver successfully, you will find “Fastboot interface” in device manager. As below

2) Install BP part driver

(i) Power off  handset, press “Power key + Voice Down key” until the screen shows QPST mode, plug in 5Pin USB cable, Unzip “Driver”, select HK11-VB717-27_1.0.56 driver file, install BP driver.
Path: Right click on My computer>Manage>Device manager>Tiyanyu HS-USB Driver (Yellow notification)>Update driver software>browse path> HK11-VB717-27_1.0.56\Win32\x86\free >Continue anyway>finish.
(ii) When your BP driver is installed successfully, you will find Qualcomm HS-USB ports in device manager. As below:



Software Upgrading:

1.Download BP
Open Primo Download V1.2.3 tool, set your handset into BP mode (Power key+ Voice down key) and connect your phone with USB cable.




1. Click set path>Browse folder>Select 592522_8550_WCDMA_V000001
2. Click Download All


2.AP Download:

Open Primo Flasher V1.0 tool, set your handset into AP mode (Power key+ Voice up key) and connect your phone with USB cable.

1. Click Set path>Browse folder>Select 592522_8550_V001006
2. Click Ok for Start download.

Note: If your antivirus detects Primo Flash Tool as virus, disable your antivirus till software is finish.
 

No comments:

Post a Comment